Dip Switches - IBM 4400-006 - 4400 Model 006 B/W Direct Thermal User Manual

Chapter 1
Interfaces

DIP Switches

On the back of the printer, you will find a small window where you
can access two DIP switches labeled 1 and 2 (see Figure 2 on
page 24). The functions of the DIP switches are explained in
Table 4.
NOTE: The DIP switches are not marked with "on" or "off" labels.
Table 3. 10/100Base-T DIP Switch Settings (Basic Ethernet)
DIP Switch
1
up
down
up
down
26
Instead, the status of the switch is indicated by its position,
up or down. If the interface card has been installed upside
down (i.e., the DIP switches are to the left of the cable
connector), your DIP switch positions will be reversed and
the settings inverted.
2
up Normal operation. With both DIP switches in
the "off" position, the Ethernet Interface boots
up using the settings in flash memory rather
than the default settings.
up Factory default. With the DIP switches in this
configuration, the Ethernet Interface boots up
and all settings stored in flash memory are
erased except the Ethernet address and key
value.
down Print Test Page.With the DIP switches in this
configuration, the Basic Ethernet Interface
boots up and immediately prints a test page
containing a configuration summary.
down Reserved. This DIP switch configuration is not
for customer use. Please refer to the Setup
Guide for details.
Comments