IBM 4400-006 - 4400 Model 006 B/W Direct Thermal User Manual page 275

SMART
set snmp syslog index [-]active
The Ethernet Interface can also log SNMP alert messages to
the defined SYSLOG host (see the 'set sysinfo syslog'
command description). Use this command to enable or disable
logging of alert messages for an SNMP alert table entry.
The index is the index number of the SNMP alert table.
"active" enables alert message logging, "-active" disables it.
SMART
set snmp alerts index [-]all | [[-]warning]
[[-]offline] [[-]mediainput]
[[-]mediapath] [[-]marker] [[-]cutter] [[-]barcode]
[[-]scanner] [[-]intervention] [[-]consumable]
[[-]label]set snmp alerts 1 warning -cutter]
example: enable warning alerts and disable cutter alerts for SNMP
table entry 1
This specifies which alert groups are enabled for reporting via
an SNMP manager, e-mail alert message, and/or Unix syslog
daemon. See Table 5 on page 63 for a description of specific
printer events belonging to each group.
The index is the index number of the SNMP manager/alert
table.
"-all" disables and "all" enables reporting of alerts in all alert
groups. Individual alert groups can be selectively enabled or
disabled via combinations of alert group switches.
set sysinfo label|name newname
example: set sysinfo name salesprinter
Set a descriptive name defined by newname for Ethernet
Interface identification purposes. This is not used in the
operation of the print server in any way.
set sysinfo location description
example: set sysinfo location salesdept
Set the physical location of the Ethernet Interface. This is for
identification purposes and is not used in the operation of the
print server in any way.
Set Commands
[[-]mediaoutput]
275