IBM 4400-006 - 4400 Model 006 B/W Direct Thermal User Manual page 265

store tcpip ifnum frametype [[-]ethernet2]
[[-]802.2snap]
example: store tcpip 1 frametype ethernet2 802.2snap
Control which frame type(s) is supported with the TCP/IP
protocol. By default, both Ethernet2 and 802.2snap are
enabled, but normal TCP/IP communications rely on Ethernet
2. This setting has no affect on other supported network
protocols (e.g., Novell).
store tcpip route add|del host|net IPaddress ifnum
example: store tcpip route add net 192.75.12.0 1
Add or delete a static route to a particular TCP/IP host or
subnet specified by IPaddress so the Ethernet Interface
knows how to communicate with it. Normally one entry for a
default router/gateway is all that is needed for communications
between different subnets. Please see the next command for
details.
store tcpip route add|del default routerIPaddress ifnum
example: store tcpip route add default 192.75.11.1 1
Store a default router/gateway defined by routerIPaddress
so the Ethernet Interface knows where to direct packets
destined for another subnet. It is easier to store one default
entry rather than an entry per remote host or network as in the
previous command.
store tcpip tcp rxwin packets
example: store tcpip tcp rxwin 2
Determine the receive window size for the Ethernet Interface.
Usually the packets value ranges from 2 to 8, with the lower
number allowing for more simultaneous TCP connections with
the print server.
Store Commands
265