Configuring An As/400 Tcp/Ip Interface With Addtcpifc - IBM 4400-006 - 4400 Model 006 B/W Direct Thermal User Manual

Configuring An AS/400 TCP/IP Interface With ADDTCPIFC

8. The next step depends on your AS/400 release. See
"Configuring PSF/400 For IPDS On V3R7 Or V4R1" on page
205 to configure your printer.
NOTE: When the IPDS feature is installed, the queue name 'd4prn'
is not available.
9. Verify the printer is ON using the VFYCFG command.
10. Verify that TCP/IP has been started using the STRTCP
command.
11. Test your configuration. See "Verifying The IPDS Configuration
On AS/400" on page 219.
12. To share the printer on the network, verify that the necessary
parameters have been set correctly. See "Sharing The AS/400
Printer On The Network" on page 220.
13. If you have problems, refer to "AS/400 Troubleshooting" on
page 222.
Configuring An AS/400 TCP/IP Interface With
ADDTCPIFC
NOTE: Do not enter the IP address of the Ethernet Interface. Do
not set the AS/400 interface address to the same address
as the Ethernet Interface IP address. Also, do not add the
Ethernet Interface to the AS/400 TCP/IP interface list.
Configuring An Interface For Ethernet
ADDTCPIFC is used to add a TCP/IP interface to AS/400. This step
configures the AS/400 for attachments to a TCP/IP network.
1. At the AS/400 command line, enter the following command:
ADDTCPIFC INTNETADR ('9.99.15.188') LIND(ETHLAN)
SUBNETMASK('255.255.255.0')
203