Configuring A Default Router/Gateway; Unix Host Configuration; Manual System V Host Setup - IBM 4400-006 - 4400 Model 006 B/W Direct Thermal User Manual

Chapter 5

Unix Host Configuration

2. At the "Network Configuration" HTML form that displays, click in
the first field below the "Gateway" heading and type in the IP
address of the default router/gateway for the Ethernet Interface
subnet.
3. Click the SUBMIT button when done and physically repower
the print server to make sure the new setting is in effect.

Configuring A Default Router/Gateway

To configure a default router/gateway using the Ethernet Interface
internal command shell, npsh:
1. Telnet to the Ethernet Interface, and log in as root with no
password.
2. At the system prompt, enter the command to store the default
router/gateway address:
store tcpip route add default routerIPaddress 1
(e.g., store tcpip route add default 192.75.12.0 1)
3. Repower the printer to have the stored setting to take effect.
Unix Host Configuration
There may be times when you would prefer or have to perform the
manual setup steps for a new printer definition. There may also be
times when you require a less common print solution such as direct
socket capabilities. This section covers these additional setups.

Manual System V Host Setup

This setup involves any Unix operating system using System V
print spooling (e.g., SCO, Solaris
means an interface file is used for each defined printer and, in the
case of any System V print setup involving an Ethernet Interface,
the RSHD protocol is used to transfer data from the host to the print
server.
116
® ® ®
, HP-UX , DG/UX , etc.). This