IBM 4400-006 - 4400 Model 006 B/W Direct Thermal User Manual page 161

16. Click on a branch in the tree (i.e., context) that you would like to
create the Ethernet Interface print server object in.
NOTE: If the context you choose is different than the one the file
server object for the file server you are using is in, you must
set the context on the Ethernet Interface. See "Setting The
Ethernet Interface NDS Context (NDS Setups)" on page
156.
17. Click the right mouse button to bring up a submenu and choose
"Create..." from this menu.
18. A dialog box titled "New Object" displays. In the "Class of new
object" list, select "Print Server" and click "OK."
19. Type the name for the print server in the "Print Server name"
field. By default, the name is "M_xxxxxx" where "xxxxxx"
equals the last six digits of the print server's Ethernet address
(found on the bottom of the device, e.g., "M_091C1A").
NOTE: The name you use here must match the name stored on
the Ethernet Interface. This name can be found by using
the list pserver command. See "List Commands" on
page 279 for more information.
20. Select the "Define additional properties" and click the "Create"
button.
21. Click "Assignments" in the dialog box and then the "Add..."
button.
22. Select the printer you created earlier.
23. Click "OK" to assign this printer to this print server.
24. Click "OK" to close the "Printer Servers Details" dialog box and
make the changes permanent.
25. Physically repower the printer to make the new settings take
effect.
NDS PSERVER Setup (Netware 4.x/5.x)
161