Address Switches; Terminator Switch - IBM 5225 1 Operator's Manual

Address Switches
Terminator Switch
The two position
(I
or 0) rocker-type address switches establish the address of
your printer. These switches were set when your printer was set up. The following
illustrations show the switch positions for addresses 0 through 6. A printer address
of 7 is invalid.
Note: If your printer does not have the Cable-Thro feature, its address is automat-
ically 0 and cannot be changed.
Printer
address
Printer switches
address 4 2 1
0
2
3
4
5
6
printer address
=
2
2
The terminator switch must be set to position 1 if only one cable is connected to
the printer. If two cables are connected to the printer, the terminator switch must
be set to position 2.
Printer Controls 2-21