Chapter 15
Complete Command List
IMPORTANT
Do not delete the root user, or you will be unable to configure
any further settings on the print server. You will have to go
back to factory defaults to correct this problem.
set user passwd username password
example: set user passwd eng mplex1
Assign a password to a defined user on the Ethernet Interface.
This password must be less than eleven characters.
set user type username root|guest
example: set user type eng root
Assign root or guest privileges to a particular user defined by
username. Guest permissions allow viewing of settings only.
Root permissions allow complete control of the Ethernet
Interface.
set user from default
Set all user settings back to factory defaults.
set user from stored
Set all current user settings to the values stored in flash
memory.
set user passwd snmp com_name
Set the new SNMP R/W community name as the com_name
value.
set var variablename variablestring
example: set var LANDSCAPE 0x1b 0x26 0x6c 0x31 0x4f
Define a new variable to be used in header, trailer, or switch
strings on the Ethernet Interface and call it variablename.
The variablestring can be a space-separated list of words,
hexadecimal numbers (e.g., 0x04), or references to other pre-
defined variables. It is easiest to make up the
variablestring with hexadecimal values, as shown in the
example.
NOTE: One variable counts as one element within header and
NOTE: Defined variables are referenced in strings by placing a "$"
278
trailer strings.
before the variable name (e.g., set model m1 trailer
$FF).