Configuration Tools - IBM 4400-006 - 4400 Model 006 B/W Direct Thermal User Manual

Chapter 2

Configuration Tools

Configuration Tools
There are two parts to a Ethernet Interface setup:
•
Configuring the Ethernet Interface so it can be seen on the
network. This involves network-related settings (e.g., an IP
address within TCP/IP environments) configured through the
built-in command shell, npsh, or from the control panel, or with
IBM utility software (e.g. 4400 Ethernet Utility).
NOTE: Ethernet configuration via the printer control panel may
32
A
Figure 3. Physical Setup
only be done using the Smart Ethernet.
A
Network Connector