IBM 4400-006 - 4400 Model 006 B/W Direct Thermal User Manual page 214

Chapter 10
Configuring An IPDS Printer On The AS/400
3. The following parameters are recommended: PSF
The name used for this PSF configuration object. The name must
match the user-defined object name (USRDFNOBJ) in the printer
DEVD.
PSF configuration (PSFCFG)
The name used for this PSF configuration object. The name must
match the user-defined object name (USRDFNOBJ) in the printer
DEVD.
IPDS pass through (IPDSPASTHR)
Specifies whether IPDS pass-through is done for the device. This
parameter defaults to *NO.
NOTE: Not all SCS or IPDS spooled files are eligible for IPDS
Release timer (RLSTMR)
Specifies the amount of time to wait before a session or dialog is
released without terminating the writer. The ACTRLSTMR
parameter specifies when this timer is to be activated. Set the
parameter to a value at least equal to the TIMEOUT value on the
printer. IBM recommends *SEC15.
Page size control (PAGSIZCTL)
Specifies if the page size (forms) is set by PSF/400. Usually set to
*YES.
Remote Location name or address (RMTLOCNAME)
Enter the IP address or hostname of the printer.
214
configuration (PSFCFG)
pass-through. Some files may contain special functions
that require transform to AFPDS for correct printing.
Specifying IPDS pass-through allows only those spooled
files eligible for IPDS pass-through to bypass the extra
transforms which may improve performance.