IBM 4400-006 - 4400 Model 006 B/W Direct Thermal User Manual page 228

Chapter 11
Configuring PSF for MVS to Print IPDS Files
Define the Communications Control Unit to MVS
If you have not already done so, define the communications control
unit for the MVS host, such as the 3172 or the 3745 control unit, to
MVS. Use either an MVS configuration program (MVSCP) or a
hardware configuration definition (HCD), depending on the version
of your MVS system:
•
When using a version earlier than MVS 4.1.0, use an MVSCP.
•
When using a version of MVS 4.1.0 or later, use an HCD or an
MVSCP.
For more information about using these methods, refer to:
•
MVS/ESA* Migration Planning: Dynamic I/O Configuration
•
MVS/ESA Hardware Configuration: Using the Dialog
Modify the TCP/IP Profile in MVS
The TCP/IP profile contains system configuration statements used
to initialize the TCP/IP address space. Of those statements, the
following are subject to special considerations when you are
printing from PSF/MVS on TCP/IP-attached printers. Samples of
these statements are printed in bold in the example shown in
Figure 34.
228