IBM 4400-006 - 4400 Model 006 B/W Direct Thermal User Manual page 269

set logpath logpath type [[-]job] [[-]user] [[-]pgcnt]
[[-]cksum] [[-]printer] [[-]ioport]
example: set logpath l2 type job user printer pgcnt
Establish the type of printer and print job logging to be done
within this logpath. The options are:
job
user
pgcnt
cksum
printer
ioport
set logpath logpath port TCPportnumber| email|syslog
example: set logpath l3 port 2000
Determine where the log information should be sent for a print
job or attached printer. The choices are:
TCPportnumber TCP port number ranging from 1024 to
SMART
email
syslog
set logpath from default
Set all logpath settings back to factory defaults.
set logpath from stored
Set all current logpath settings to the values stored in flash
memory.
Job ID, username, etc.
User ID along with three messages per job
about start and finish.
For total pages printed in a job.
16-bit checksum value to confirm integrity of
data printed.
For special printer feedback.
Printer error messages determined through
the parallel port pins.
65000.
Particular user's email address. This address
is set using the set sysinfo email
emailname@IPaddress command.
A central TCP/IP host running the SYSLOG
daemon. This host is set using the set
sysinfo syslog IPaddress command.
Set Commands
269