IBM 4400-006 - 4400 Model 006 B/W Direct Thermal User Manual page 38

Chapter 2
Configuration Tools
The Netmask must be the same in both locations. For example,
if the Netmask is listed as 255.255.255.0 in NETWORK
INTERFACES and is listed as 255.255.255.255 in the TCP/IP
ROUTING TABLE, they do not match and you must correct it
for the Gateway. Also, if a Gateway Address was entered,
verify that "xxx.xxx.xxx.xxx is alive" is printed under the Default
Gateway Ping Test, where xxx.xxx.xxx.xxx is the Gateway
Address. If a Gateway Address was not entered, the Default
Gateway Ping test is not required and will not display on the
page.
If the Netmask does not match, complete the following steps:
a. Place the printer offline.
b. Using the front panel, modify the Gateway value to 0.0.0.0.
c. Place the printer online and wait for the "E-NET READY"
d. Place the printer offline and enter the Gateway Address
e. Place the printer online and wait for the "E-NET READY"
Your Ethernet Interface is now configured and connected to your
network.
38
(non-configured).
message to display.
you desire.
message. This saves the new Gateway Address.