5.1.3 1A - SET DISPLAY ADDRESS
This command is used to set the addresses of the 2 display(s) that have to be monitored for connection by
the fiscal unit.
5.1.3.1 Command Format
-----------------------------------------------------------------------
BYTE BIT CONTENT
0-1
1B66 - cmd prefix
2
1A - Set Display Address
3
Cmd. Extension
7-0 Reserved (always = ' 0 x00' )
4-7
Password
8-9
First Display Address
10-11
Second Display Address
-----------------------------------------------------------------------
Notes:
1. Specify the ASCII representation of the hexadecimal address.
Example: for hexadecimal address x' 2A' specify ASCII characters ' 2 ' , 'A' .
Valid display addresses are: x' 2 0 ' -x'27 ' and x' 2A' -x' 2F'
2. If C4 cmd. was issued to allow single display, specify the second address as x'0000' for single
display sensing.
5.1.3.2 Set Display Address Rules
•
Display addresses are erased when RAM is cleared by activation of the J4/CE jumper.
TYPE
LENGTH
hex
2
hex
1
hex
1
ASCII
4
ASCII
2 (Note 1)
ASCII
2 (Note 1, 2)
Command Set Reference — Page 49 of 183