IBM 4400-006 - 4400 Model 006 B/W Direct Thermal User Manual page 273

set snmp
To add a user named snmp with root privileges, follow the steps
below:
1.Login to the Ethernet Interface as a root user.
2.Add a user named snmp:
set user add snmp
3.Set the user type to root:
set user type snmp root
4.Set the password for the snmp user:
set user passwd snmp snmppassword
5.Save the changes:
save
The user snmp is now created and snmppassword is the only
community string which will allow write access.
SMART
set snmp manager index ipaddress trap-community
The Ethernet Interface continuously generates traps. To set the
Ethernet Interface to send traps to a particular SNMP manager,
use this command to add an SNMP manager to the trap table.
The index is the index number of the trap table. ipaddress is
the IP address of the SNMP manager receiving traps. The
trap-community is the community string sent along with the
trap information.
SMART
set snmp trapport index udpport
Set the UDP port number in the SNMP trap manager table.
This value should correspond to the port number monitored by
the SNMP manager application running on the host at the IP
address specified in the 'set snmp manager' command.
The index is the index number of the SNMP trap manager
table. udpport is the desired UDP port number. Acceptable
values are 162, and 49152 through 65535.
Set Commands
273