IBM 4400-006 - 4400 Model 006 B/W Direct Thermal User Manual page 277

SMART
set sysinfo smtp IPaddress [port portnumber]
example: set sysinfo smtp 192.75.11.5 port 25
Define the SMTP (Simple Mail Transfer Protocol) server IP
address and port number where the mail is stored on your
network.
Default: Unconfigured, 25
set sysinfo syslog hostIPaddress
example: set sysinfo syslog 192.75.11.30
Set the IP address of the host running the SYSLOG daemon.
Ethernet Interface debugging or print job and printer logging
information can be sent to that IP address.
set sysinfo dns DNSserverIPaddress
example: set sysinfo dns 192.75.11.2
Set your DNS server IP address so the Ethernet Interface can
resolve host names when used with its built-in Telnet and
ping clients.
set sysinfo module [[-]netbios]
example: set sysinfo module -netbios
Enable and disable certain network protocol stacks within the
Ethernet Interface. Sometimes it helps to disable any protocols
you are not using on your network.
SMART
set sysinfo module [[-]novell]
example: set sysinfo module -novell
Enable and disable certain network protocol stacks within the
Ethernet Interface. Sometimes it helps to disable any protocols
you are not using on your network.
set user add|del username
example: set user add eng
Add or remove a user on the Ethernet Interface defined by
username.
Set Commands
277