IBM 4400-006 - 4400 Model 006 B/W Direct Thermal User Manual page 183

7. Try to ping this IP address to see if the Ethernet Interface can
be seen on your network. If the interface does not respond,
verify you are on the same network segment as the printer and
that the ARP entry was created.
8. Telnet into the Ethernet Interface using the same IP address as
above. Log in as root with no password.
9. At the system prompt, enter:
store tcpip from default
SMART
config http on
reset
NOTE: This will reset all TCP/IP settings to factory default and
reset the Ethernet Interface.
10. Power the printer off and then back on.
11. Set the IP address, subnet mask, and default gateway
parameters to the desired values.
SMART
12. If Web browser access does not work, telnet into the
Ethernet Interface as root. Enter the following command:
config http on
TCP/IP Access Problem
183