IBM 4400-006 - 4400 Model 006 B/W Direct Thermal User Manual page 27

NOTE: When running LMU1 emulation the test page will not print if
the ASCII Text Mode menu setting is set to Absorb. To
print the test page, under LMU1 emulation, change the
ASCII Text Mode parameter from Absorb to Auto Pass-
thru.
SMART
Table 4. 10/100Base-T DIP Switch Settings (Smart Ethernet)
DIP Switch
1
up
down
up down
down down
2
up Normal operation. With both DIP switches in
the "off" position, the Ethernet Interface boots
up using the settings in flash memory rather
than the default settings.
up Factory default. With the DIP switches in this
configuration, the Ethernet Interface boots up
and all settings stored in flash memory are
erased except the Ethernet address and key
value.
Default IP. With the Smart Ethernet and DIP
switches in this configuration, the Ethernet
Interface boots up with factory default settings.
However, the stored settings in flash memory
are intact. Setting DIP switch 2 to "on" does not
clear any settings stored in flash memory; it
boots the unit in a different state with the
settings in flash memory temporarily ignored.
Reserved. This DIP switch configuration is not
for customer use. Please refer to the Setup
Guide for details.
DIP Switches
Comments
27