Fcip Enable - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

fcip enable

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
fcip enable
To enable the FCIP feature in any switch in the Cisco MDS Family, issue the fcip enable command.
Syntax Description This command has no other arguments or keywords.
Defaults Disabled.
Command Modes Configuration mode.
Command History Release
1.3(1)
NX-OS 4.1(1b)
Usage Guidelines
The configuration and verification commands for the iSCSI feature are only available when FCIP is
enabled on a switch. When you disable this feature, all related configurations are automatically
discarded.
This command is not supported on the Cisco MDS 9124 switch, the Cisco Fabric Switch for HP c-Class
Note
BladeSystem, and the Cisco Fabric Switch for IBM BladeCenter.
Examples
The following command enables the FCIP feature.
switch(config)# fcip enable
The following command disables the FCIP feature (default).
switch(config)# no fcip enable
Related Commands Command
show fcip
Cisco MDS 9000 Family Command Reference
8-34
fcip enable
no fcip enable
Modification
This command was introduced.
This command was deprecated.
Description
Displays FCIP information.
Chapter 8 F Commands
OL-18089-01, Cisco MDS NX-OS Release 4.x