Server (Configure Session Submode) - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

Chapter 21 S Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

server (configure session submode)

To configure a data migration session, use the server command in session configuration submode. To
remove the data migration session, use then no form of the command.
Syntax Description pwwn
src_tgt pwwn
src_lun src-lun
dst_tgt pwwn
dst_lun dst-lun
Defaults
None.
Command Modes
Configure session submode.
Command History Release
3.2(1)
Usage Guidelines None.
Examples The following example shows how to configure a source target, source LUN, destination target, and
destination LUN in a session:
switch# config t
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# dmm module 3 job 1 session
switch(config-session)# server 12:13:1d:1c:2d:2d:3f:3a src_tgt 12:13:1d:1c:2d:2d:3f:3a
src_lun 0x1 dst_tgt 12:13:1d:1c:2d:2d:3f:3a dst_lun 0x5
Related Commands Command
show dmm ip-peer
show dmm srvr-vt-login
OL-18089-01, Cisco MDS NX-OS Release 4.x
server pwwn src_tgt pw-wn src_lun src-lun dst_tgt pwwn dst_lun dst-lun
no server pwwn src_tgt pw-wn src_lun src-lun dst_tgt pwwn dst_lun dst-lun
Specifies the pWWN of the server. The format is hh:hh:hh:hh:hh:hh:hh:hh,
where h is a hexadecimal number.
Specifies the pWWN of the source target. The format is
hh:hh:hh:hh:hh:hh:hh:hh, where h is a hexadecimal number.
Specifies the source LUN number in hex notation. The range is 0x0 to 0xfff.
Specifies the pWWNof the destination target. The format is
hh:hh:hh:hh:hh:hh:hh:hh, where h is a hexadecimal number.
Specifies the destination LUN in hex notation. The range is 0x0 to 0xfff.
Modification
This command was introduced.
Description
Displays job information.
Displays server VT login information.
server (configure session submode)
Cisco MDS 9000 Family Command Reference
21-23