Crypto Ike Domain Ipsec - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

crypto ike domain ipsec

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
crypto ike domain ipsec
To enter IKE configuration submode, use the crypto ike domain ipsec command.
Syntax Description
This command has no other arguments or keywords.
Defaults None.
Command Modes Configuration mode.
Command History Release
2.0(x)
Usage Guidelines
To configure IKE protocol attributes, IKE must be enabled using the crypto ike enable command.
Note This command is not supported on the Cisco MDS 9124 switch, the Cisco Fabric Switch for HP c-Class
BladeSystem, and the Cisco Fabric Switch for IBM BladeCenter.
Examples
The following example shows how enter IKE configuration mode:
switch# config terminal
switch(config)# crypto ike domain ipsec
switch(config-ike-ipsec)#
Related Commands Command
crypto ike enable
show crypto ike domain ipsec Displays IKE information for the IPsec domain.
Cisco MDS 9000 Family Command Reference
4-138
crypto ike domain ipsec
Modification
This command was introduced.
Description
Enables the IKE protocol.
Chapter 4 C Commands
OL-18089-01, Cisco MDS NX-OS Release 4.x