Crypto Ipsec Enable - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

Chapter 4 C Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

crypto ipsec enable

To enable IPsec, use the crypto ipsec enable command. To disable IPsec, use the no form of the
command.
Syntax Description This command has no other arguments or keywords.
Defaults
Disabled.
Command Modes
Configuration mode.
Command History Release
2.0(x)
Usage Guidelines To enable the IPsec, the IKE protocol must be enabled using the crypto ike enable command:
The configuration and verification commands for IPsec are only available when IPsec is enabled on the
switch. When you disable this feature, all related configurations are automatically discarded.
This command is not supported on the Cisco MDS 9124 switch, the Cisco Fabric Switch for HP c-Class
Note
BladeSystem, and the Cisco Fabric Switch for IBM BladeCenter.
Examples
The following example shows how to enable IPsec:
switch# config terminal
switch(config)# crypto ipsec enable
Related Commands Command
show crypto global domain ipsec Displays IPsec crypto global information.
show crypto map domain ipsec
show crypto transform-set
domain ipsec
OL-18089-01, Cisco MDS NX-OS Release 4.x
crypto ipsec enable
no crypto ipsec enable
Modification
This command was introduced.
Description
Displays IPsec crypto map information.
Displays IPsec crypto transform set information.
Cisco MDS 9000 Family Command Reference
crypto ipsec enable
4-141