Counter - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

counter

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
counter
To configure an indivisual counter to override the default configuration, use the counter command. To
reset the value of the counter to default value, use the no form of the command.
Syntax Description
link loss
sync-loss
invalid-crc
invalid-words
protocol-errors
rx-performance
tx-performance
state-change
poll-interval
interval
absolute/delta
rising-threshold
rising-threshold
event
event-id
falling-threshold
low-threshold
Defaults
None.
Command Modes
Configuration submode.
Command History Release
4.1(1b)
Usage Guidelines This command shows each threshold per interface and the threshold values inherited from the policies.
The falling threshold and the event need not be configured and are optional. The no counter command
Note
will reset the value of the counter to the default value.
Cisco MDS 9000 Family Command Reference
4-122
counter{link-loss | sync-loss | invalid-crc | invalid-words | protocol-error | rx-performance |
tx-performance | state-change} poll-interval interval {absolute | delta} rising-threshold
rising threshold event event id falling-threshold low threshold event event id
Configures link loss counter.
Configures sync loss counter.
Configures invalid CRC counter.
Configures invalid words counter.
Configures protocol error counter.
Counfigures RX performance counter.
Configures TX performance counter.
Configures state-change counter.
Configures poll interval for counter.
Displays poll interval in seconds.
Displays the threshold type.
Configures the upper threshold value.
Sets numerical upper threshold limit.
Configures high threshold event.
Displays event ID from event configuration.
Configures the lower threshold value.
Sets numerical low threshold limit.
Modification
This command was introduced.
Chapter 4 C Commands
OL-18089-01, Cisco MDS NX-OS Release 4.x