Ivr Enable - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

ivr enable

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
ivr enable
To enable the Inter-VSAN Routing (IVR) feature, use the ivr enable command in configuration mode.
To disable this feature, use the no form of the command.
Syntax Description This command has no arguments or keywords.
Defaults
Disabled.
Command Modes
Configuration mode.
Command History Release
1.3(1)
NX-OS 4.1(1b)
Usage Guidelines The IVR feature must be enabled in all edge switches in the fabric that participate in the IVR.
The configuration and display commands for the IVR feature are only available when IVR is enabled on
a switch.
When you disable this configuration, all related configurations are automatically discarded.
This command is not supported on the Cisco MDS 9124 switch, the Cisco Fabric Switch for HP c-Class
Note
BladeSystem, and the Cisco Fabric Switch for IBM BladeCenter.
Examples
The following command enters the configuration mode and enables the IVR feature on this switch.
switch# config terminal
Enter configuration commands, one per line.
switch(config)# ivr enable
Related Commands Command
show ivr
Cisco MDS 9000 Family Command Reference
11-128
ivr enable
no ivr enable
Modification
This command was introduced.
This command was deprecated.
Description
Displays IVR feature information.
End with CNTL/Z.
OL-18089-01, Cisco MDS NX-OS Release 4.x
Chapter 11 I Commands