Server (Dmm Job Configuration Submode) - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

server (DMM job configuration submode)

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
server (DMM job configuration submode)
To add a server HBA port to the DMM job, use the server command in DMM job configuration submode.
To remove the server HBA port, use the no form of the command.
Syntax Description vsan vsan-id
pwwn port-wwn
Defaults None.
Command Modes DMM job configuration submode.
Command History Release
3.2(1)
Usage Guidelines None.
Examples The following example shows how to add server information to a DMM job:
switch# config t
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# dmm module 3 job 1 create
Started New DMM Job Configuration.
Do not exit sub-mode until configuration is complete and committed
switch(config-dmm-job)# server vsan 3 pwwn 1d:22:3a:21:3c:44:3b:51
switch(config-dmm-job)#
Related Commands Command
show dmm ip-peer
show dmm srvr-vt-login
Cisco MDS 9000 Family Command Reference
21-24
server vsan vsan-id pwwn port-wwn
no server vsan vsan-id pwwn port-wwn
Specifies the VSAN ID. The range is 1 to 4093.
Specifies the port worldwide name of the server HBA port. The format is
hh:hh:hh:hh:hh:hh:hh:hh, where h is a hexadecimal number.
Modification
This command was introduced.
Description
Displays job information.
Displays server VT login information.
Chapter 21 S Commands
OL-18089-01, Cisco MDS NX-OS Release 4.x