Qos Control Priority - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

Chapter 19 Q Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

qos control priority

To enable the QoS priority assignment for control traffic feature on the Cisco MDS 9000 family of
switches, use the qos control command in configuration mode. To revert to the factory default, use the
no form of the command.
Syntax Description
0
Defaults
Enabled and priority 7 are the defaults.
Command Modes
Configuration mode.
Command History Release
1.0(2)
Usage Guidelines None.
Examples
The following example sets the QoS priority assignment to the highest level.
switch# config terminal
switch(config)# no qos control priority 0
Related Commands Command
show qos
OL-18089-01 Cisco MDS NX-OS Release 4.x
qos control priority 0
no qos priority control 0
Specifies the lowest priority. To revert to the highest priority, use the no form
of the command.
Modification
This command was introduced.
Description
Displays configured QoS information.
Cisco MDS 9000 Family Command Reference
qos control priority
19-3