Node - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

Chapter 16 N Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

node

To configure Cisco SME switch, use the node command. To disable this command, use the no form of
the command.
Syntax Description local
A.B.C.D
X:X::X/n
DNS name
Defaults
None.
Command Modes
Cisco SME cluster configuration submode.
Command History Release
3.2(2)
Usage Guidelines None.
Examples The following example adds the Cisco SME interface from a local switch:
switch# config t
switch(config)# sme cluster c1
switch(config-sme-cl)# node local
switch(config-sme-cl-node)#
The following example adds the Cisco SME interface from a remote switch:
switch# config t
switch(config))# sme cluster c1
switch(config-sme-cl)# node 171.71.23.33
switch(config-sme-cl-node)#
Related Commands Command
show sme cluster cluster
name node
OL-18089-01, Cisco MDS NX-OS Release 4.x
node {local | {A.B.C.D | X:X::X /n| DNS name}}
no node {local | {A.B.C.D | X:X::X /n| DNS name}}
Configures the local switch.
Specifies the IP address of the remote switch in IPv4 format.
Specifies the IP address of the remote switch in IPv6 format.
Specifies the name of the remote database.
Modification
This command was introduced.
Description
Displays Cisco SME node information about a local or remote switch.
Cisco MDS 9000 Family Command Reference
node
16-3