Sdv Virtual-Device Name - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

Chapter 21 S Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

sdv virtual-device name

To create a virtual device name for a specified VSAN, use the sdv virtual-device name command in
configuration mode. To remove the name, use the no form of the command.
Syntax Description name device-name
vsan vsan-id
Defaults
Disabled.
Command Modes Configuration mode.
Command History Release
3.1(2)
Usage Guidelines
To use this command, you must enable SDV using the sdv enable command.
No more than 1000 virtual targets can be created in a single VSAN.
No more than 128 devices can be defined as virtual devices.
Examples The following example shows how to create a virtual device name for a VSAN, and then specify both
the primary and secondary pWWNs.
switch# config t
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# sdv virtual-device name vdev1 vsan 2
switch(config-sdv-virt-dev)# pwwn 21:00:00:04:cf:cf:45:40 primary
switch(config-sdv-virt-dev)# pwwn 21:00:00:04:cf:cf:38:d6
The following example shows how to remove the virtual device name.
switch# config t
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# no sdv virtual-device name vdev1 vsan 2
Related Commands Command
show sdv database
sdv enable
OL-18089-01, Cisco MDS NX-OS Release 4.x
sdv virtual-device name device-name vsan vsan-id
no sdv virtual-device name device-name vsan vsan-id
Specifies the name of the device. The maximum size is 32.
Specifies the number of the VSAN. The range is 1 to 4093.
Modification
This command was introduced.
Description
Displays the SDV database.
Enables SDV.
Cisco MDS 9000 Family Command Reference
sdv virtual-device name
21-19