Fabric-Membership - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

fabric-membership

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
fabric-membership
To configure a node to a fabric, use the fabric-membership command. To remove the node from the
fabric, use the no form of the command,
Syntax Description fabric name
Defaults
None.
Command Modes Cisco SME cluster node configuration submode.
Command History Release
3.2(2)
Usage Guidelines
Use the fabric-membership command to put a node in a fabric.
This command has to be configured before the interface sme slot/port [force] can be accepted. It also
cannot be removed if the interface sme slot/port [force] command is enabled.
Examples
The following example specifies a fabric to which the node belongs :
switch# config t
switch(config)# sme cluster clustername1
switch(config-sme-cl)# node local
switch(config-sme-cl-node)# fabric-membership f1
Related Commands Command
interface sme slot/port [force]
shutdown
show interface sme
Cisco MDS 9000 Family Command Reference
8-10
fabric-membership fabric name
no fabric-membership fabric name
Specifies the fabric name. The maximum length is 32 characters.
Modification
This command was introduced.
Description
Configures the Cisco SME interface to a cluster.
Enables or disables an interface.
Displays interface information.
Chapter 8 F Commands
OL-18089-01, Cisco MDS NX-OS Release 4.x