Ivr Service-Group Activate - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

ivr service-group activate

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
ivr service-group activate
To activate an inter-VSAN routing (IVR) service group, use the ivr service-group activate command in
configuration mode. To disable this feature, use the no form of the command.
Syntax Description default-sg-deny
Defaults
Deactivated.
Command Modes Configuration mode.
Command History Release
3.0(1)
Usage Guidelines
You must activate a configured IVR service group for the IVR service group to take effect. Once a
configured IVR service group is activated, it replaces the currently activated service group, if there is
one.
Activating an IVR service group with the default-sg-deny option sets the default service group policy
to deny. To change the default service group policy to allow, issue the ivr service-group activate
command again, but without the default-sg-deny option.
Examples The following example activates the default IVR service group:
switch# config terminal
switch(config)# ivr service-group activate
The following example sets the default IVR service group policy to deny:
switch# config terminal
switch(config)# ivr service-group activate default-sg-deny
The following example disables the default service group:
switch# config terminal
switch(config)# no ivr service-group activate
Cisco MDS 9000 Family Command Reference
11-132
ivr service-group activate [default-sg-deny]
no ivr service-group activate [default-sg-deny]
Modification
This command was introduced.
Sets the policy to deny for the default service group.
Chapter 11 I Commands
OL-18089-01, Cisco MDS NX-OS Release 4.x