Shutdown (Interface Configuration Submode) - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

shutdown (interface configuration submode)

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
shutdown (interface configuration submode)
To disable an Cisco SME interface, use the shutdown command. To enable the interface, use the no form
of the command.
Syntax Description This command has no arguments or keywords.
Defaults
None.
Command Modes
Interface configuration submode.
Command History Release
3.2(2)
Usage Guidelines The default state for Cisco SME interfaces is shutdown. Use the no shutdown command to enable the
interface to carry traffic.
The show interface command shows that the Cisco SME interface is down until the interface is added
to a cluster.
Examples The following example enables a Cisco SME interface:
switch# config t
switch(config)# interface sme 4/1
switch(config-if)# no shutdown
The following example disables a Cisco SME interface:
switch# config t
switch(config)# interface sme 4/1
switch(config-if)# shutdown
Related Commands Command
show interface sme
Cisco MDS 9000 Family Command Reference
21-34
shutdown
no shutdown
Modification
This command was introduced.
Description
Displays information about the Cisco SME interface.
Chapter 21 S Commands
OL-18089-01, Cisco MDS NX-OS Release 4.x