Interface Fc-Tunnel - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

Chapter 11 I Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

interface fc-tunnel

To configure a Fibre Channel tunnel and facilitate RSPAN traffic, use the interface fc-tunnel command.
To remove a configured tunnel or revert to factory defaults, use the no form of the command.
Syntax Description number
destination ip-address
explicit-path path-name Specifies a name for the explicit path. Maximum length is 16 alphanumeric
source ip-address
Defaults
None.
Command Modes
Configuration mode.
Command History Release
1.2(1)
Usage Guidelines None.
Examples
The following example initiates the FC tunnel (100) in the source switch (switch S):
switch(config)# config terminal
switch(config)# interface fc-tunnel 100
switch(config-if)#
The following example maps the IP address of the source switch (switch S) to the FC tunnel (100):
switchS(config-if)# source 209.165.200.226
The following example maps the IP address of the destination switch (switch D) to the FC tunnel (100):
switch(config-if)# destination 209.165.200.227
OL-18089-01, Cisco MDS NX-OS Release 4.x
interface fc-tunnel number
destination ip-address
explicit-path path-name
source ip-address]
no interface fc-tunnel number
no destination ip-address |
no explicit-path path-name
no source ip-address
no interface fc-tunnel number
Specifies a tunnel ID range from 1 to 255.
Maps the IP address of the destination switch.
characters.
Maps the IP address of the source switch.
Modification
This command was introduced.
Cisco MDS 9000 Family Command Reference
interface fc-tunnel
11-25