Ivr Zone Name - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

Chapter 11 I Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

ivr zone name

To configure a zone for Inter-VSAN Routing (IVR), use the ivr zone name command. To disable a zone
for IVR, use the no form of the command.
Syntax Description ivz-name
Defaults
None.
Command Modes Configuration mode.
Command History Release
1.3(1)
Usage Guidelines
This command enters IVR zone configuration submode.
Examples
The following command enters the configuration mode, enables the IVR feature, creates an IVZ, and
adds a pWWN-VSAN member.
switch# config terminal
switch(config)# ivr enable
switch(config)# ivr zone name Ivz_vsan2-3
switch(config-ivr-zone)# member pwwn 21:00:00:e0:8b:02:ca:4a vsan 3
Related Commands Command
show ivr
OL-18089-01, Cisco MDS NX-OS Release 4.x
ivr zone name ivzs-name
no ivr zone name ivz-name
Specifies the IVZ name. Maximum length is 59 characters.
Modification
This command was introduced.
Description
Displays IVR feature information.
Cisco MDS 9000 Family Command Reference
ivr zone name
11-143