Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual page 937

Chapter 20 R Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
rspan-tunnel
To associate and bind the SPAN tunnel (ST) port with the RSPAN tunnel, use the rspan-tunnel
command.
Syntax Description rspan-tunnel
interface
fc-tunnel tunnel-id
Defaults
None.
Command Modes
Interface configuration submode.
Command History Release
1.2(1)
Usage Guidelines The interface is not operationally up until the Fibre Channel tunnel mapping is configured in the source
and destination switches.
Examples The following example configures an interface to associate and bind the ST port with the RSPAN tunnel
and enables traffic flow trough this interface..
switchS# config t
switchS(config)# interface fc2/1
switchS(config-if)# rspan-tunnel interface fc-tunnel 100
switchS(config-if)# no shutdown
OL-18089-01, Cisco MDS NX-OS Release 4.x
rspan-tunnel interface fc-tunnel tunnel-id
rspan-tunnel
Configures the remote SPAN (RSPAN) tunnel.
Specifies the interface to configure this tunnel.
Specifies the FC tunnel interface. The range is 1 to 255.
Modification
This command was introduced.
Cisco MDS 9000 Family Command Reference
rspan-tunnel
20-47