Nwwn (Dpvm Database Configuration Submode) - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

nwwn (DPVM database configuration submode)

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
nwwn (DPVM database configuration submode)
To add a device to a dynamic port VSAN membership (DPVM) database using the nWWN, use the
nwwn command in DPVM database configuration submode. To remove a device from a DPVM database
using the nWWN, use the no form of the command.
Syntax Description
nwwn-id
vsan vsan-id
Defaults None.
Command Modes
DPVM database configuration submode.
Command History Release
2.0(x)
Usage Guidelines To use this command, DPVM must be enabled using the dpvm enable command.
Examples The following example shows how to add an entry to the DPVM database.
switch# config terminal
switch(config)# dpvm database
switch(config-dpvm-db)# nwwn 11:22:33:44:55:66:77:88 vsan 1
The following example shows how to delete an entry from the DPVM database.
switch(config-dpvm-db)# no nwwn 11:22:33:44:55:66:77:88 vsan 1
Related Commands Command
dpvm database
show dpvm
Cisco MDS 9000 Family Command Reference
16-16
nwwn nwwn-id vsan vsan-id
no nwwn nwwn-id vsan vsan-id
Specifies the node WWN ID. The format is hh:hh:hh:hh:hh:hh:hh, where h
is a hexadecimal number.
Specifies the VSAN ID. The range is 1 to 4093.
Modification
This command was introduced.
Description
Configures the DPVM database.
Displays DPVM database information.
Chapter 16 N Commands
OL-18089-01, Cisco MDS NX-OS Release 4.x