Iscsi Save-Initiator - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

iscsi save-initiator

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
iscsi save-initiator
To permanently save the automatically-assigned nWWN/pWWN mapping, use the iscsi save-initiator
command.
Syntax Description ip-address ip-address
name name
Defaults
If initiator name or IP address is not specified, the nWWN/pWWN mapping for all initiators becomes
permanent.
Command Modes Configuration mode.
Command History Release
1.3(1)
Usage Guidelines After executing the iscsi save-initiator command, issue the copy running-config startup-config to save
the nWWN/pWWN mapping across switch reboots.
After a dynamic iSCSI initiator has logged in, you may decide to permanently save the automatically
assigned nWWN/pWWN mapping so this initiator uses the same mapping the next time it logs in.
You can convert a dynamic iSCSI initiator to static iSCSI initiator and make its WWNs persistent.
You cannot convert a dynamic iSCSI initiator to a static iSLB initiator or a dynamic iSLB initiator to a
Note
static iSCSI initiator.
Note This command is not supported on the Cisco MDS 9124 switch, the Cisco Fabric Switch for HP c-Class
BladeSystem, and the Cisco Fabric Switch for IBM BladeCenter.
Examples The following example shows how to save the nWWN/pWWN mapping for all the initiators.
switch(config)# iscsi save-initiator
The following example shows how to save the nWWN/pWWN mapping for an initiator named
iqn.1987-02.com.cisco.initiator.
switch(config)# iscsi save-initiator name iqn.1987-02.com.cisco.initiator
Cisco MDS 9000 Family Command Reference
11-96
iscsi save-initiator [ip-address ip-address | name name]
Specifies the initiator IP address.
Specifies the initiator name to be used from 1 to 255 characters. The
minimum length is 16 characters.
Modification
This command was introduced.
Chapter 11 I Commands
OL-18089-01, Cisco MDS NX-OS Release 4.x