Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual page 684

ipv6 route
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
The following example configures a fully specified static route on a Gigabit Ethernet interface.
switch(config)# ipv6 route 2001:0DB8::/32 gigabitethernet 3/2
The following example configures a recursive static route to a specified next hop address.
switch(config)# ipv6 route 2001:0DB8::/32 2001:0DB8:2002::1
The following example configures a recursive static route to a specified next hop address, from which
the output interface is automatically derived, and to a specified interface.
switch(config)# ipv6 route 2001:0DB8::/32 2001:0DB8:2002::1 gigabitethernet 3/2
The following example configures a static IPv6 route with an administrative distance of
20.
switch(config)# ipv6 route 2001:0DB8::/32 interface gigabitethernet 2/0 distance 20
Related Commands ipv6 access-list
ipv6 routing
show ipv6 access-list
show ipv6 route
show ipv6 routing
Cisco MDS 9000 Family Command Reference
11-78
Configures an IPv6 access control list (ACL) and enters IPv6-ACL
configuration submode.
Enables IPv6 unicast routing.
Displays a summary of ACLs.
Displays the static IPv6 routes configured on the switch.
Displays the IPv6 unicast routing configured on the switch.
Chapter 11 I Commands
OL-18089-01, Cisco MDS NX-OS Release 4.x