Server (Tacacs+ Configuration) - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

server (tacacs+ configuration)

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
server (tacacs+ configuration)
To configure a TACACS+ server, use the server command in TACACS+ configuration submode. To
discard the configuration, use the no form of the command.
Syntax Description ipv4-address
ipv6-address
dns-name
Defaults None.
Command Modes TACACS+ configuration submode.
Command History Release
1.3(1)
3.0(1)
Usage Guidelines
None.
Examples
The following example shows the server command in RADIUS configuration submode.
switch# config terminal
switch(config)# aaa group server tacacs+ testgroup
switch(config-tacacs+)# server myserver
Related Commands Command
tacacs-server host
show tacacs-server
Cisco MDS 9000 Family Command Reference
21-26
server [ipv4-address | ipv6-address | dns-name]
no server [ipv4-address | ipv6-address | dns-name]
(Optional) Specifies the TACACS+ server IP address in the format A.B.C.D.
(Optional) Specifies the TACACS+ server IP address in the format X:X::X.
(Optional) Specifies the TACACS+ DNS server name. The maximum size
is 255.
Modification
This command was introduced.
Added the ipv6-address argument.
Description
Configures TACACS+ server parameters.
Displays TACACS+ server configuration parameters.
Chapter 21 S Commands
OL-18089-01, Cisco MDS NX-OS Release 4.x