Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual page 497

Chapter 7 E Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
get-type
exact
next
exit-comb
and
or
exit-time time
polling-interval
interval
temperature
module slot
sensor number
threshold
any
major
mi nor
Defaults
None.
Command Modes Embeded Event Manager.
Command History Release
NX-OS 4.1(2)
Usage Guidelines
None.
Examples
The following example shows how to specify the event criteria for an EEM applet that is run by matching
a Cisco NX-OS command line interface (CLI) command.
switch(config-applet)# event cli match "shutdown"
The following example show how to specify an event criteria for an EEM applet that is run when the
defined critical_errors counter exceeds the entry value:
switch(config)# event manager applet eventcntr-applet
switch(config-applet)# event counter name critical_errors entry-val 3 entry-op gt
switch(config-applet)#
OL-18089-01, Cisco MDS NX-OS Release 4.x
Specifies the type of SNMP get operation to be applied to the object ID
specified by the OID value argument.
Retrieves the object ID specified by the OID value argument.
Retrieves the object ID that is the alphanumeric successor to the object ID
specified by the OID value argument.
(Optional) Indicates the combination of exit conditions that must be met
before event monitor is reenabled.
(Optional) Specifies that an exit comparison operator, an exit object ID
value, and an exit time value must exist.
(Optional) Specifies that an exit comparison operator and an exit object ID
value or an exit time value must exist.
Specifies the time interval between consecutive polls. The value argument
is an integer that represents seconds in the range from 1 to 4294967295. The
minimum polling interval is 1 second.
Specifies temperature event specification.
(Optional) Specifies module number. The slot range is from 1 to 10.
(Optional) Specifies sensor number.
Specifies major or minor threshhold.
Specifies major or minor threshold.
Specifies major threshold.
Specifies minor threshold.
Modification
This command was introduced.
Cisco MDS 9000 Family Command Reference
event
7-11