Install Ssi - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

Chapter 11 I Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

install ssi

To perform a nondisruptive upgrade of the SSI image on an SSM, use the install ssi command.
Syntax Description
bootflash:
slot0:
modflash:
file-name
module slot
Defaults
None.
Command Modes EXEC mode.
Command History Release
2.1(2)
Usage Guidelines
You can use the install ssi command to upgrade or downgrade the SSI boot image if the SSM is only
configured for Fibre Channel switching. If your SSM is configured for VSFN or Intelligent Storage
Services, you must use the boot command to reconfigure the SSI boot variable and reload the module.
The install ssi command implicitly sets the SSI boot variable.
The SSM must be running EPLD version 2.1(2) to use the install ssi command. You must install the SSM
Note
on a Cisco MDS 9500 Series switch to update the EPLD.
The install ssi command does not support files located on the SSM modflash.
Note
Examples The following example installs the SSI boot image on the module in slot 2:
switch# install ssi bootflash:lm9000-ek9-ssi-mz.2.1.2.bin module 2
Related Commands Command
show boot
show module
boot
OL-18089-01, Cisco MDS NX-OS Release 4.x
install ssi {bootflash: | slot0: | modflash:} file-name module slot
Source location for the SSI boot image file.
Source location for the SSI boot image file.
Source location for the SSI boot image file.
Specifies the SSI boot image file name.
Specifies the module slot number.
Modification
This command was introduced.
Description
Displays the current contents of boot variables.
Verifies the status of a module.
Configures the boot variables.
Cisco MDS 9000 Family Command Reference
install ssi
11-19