Interface - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

interface

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
interface
To configure an interface on the Cisco MDS 9000 Family of switches, use the interface command in
configuration mode.
On a Cisco Fabric Switch for HP c-Class BladeSystem and on a Cisco Fabric Switch for IBM
Note
BladeCenter, the syntax differs as follows:
interface {bay port | ext port}
Syntax Description bay port | ext port
cpp
fc
fc-tunnel
fcip
gigabitethernet
iscsi
mgmt
port-channel
svc
vsan
Defaults
Disabled.
Command Modes
Configuration mode.
Command History Release
1.0(2)
3.1(2)
Cisco MDS 9000 Family Command Reference
11-20
interface {cpp | fc | fc-tunnel | fcip | gigabitethernet | iscsi | mgmt | port-channel | svc | vsan}
(Optional) Configures a a Fibre Channel interface on a port on a Cisco Fabric
Switch for HP c-Class BladeSystem or on a Cisco Fabric Switch for IBM
BladeCenter. The range is 0 to 48.
Configures a Control Plane Process (CPP) interface.
(Optional) Configures a Fiber Channel interface on an MDS 9000 Family
switch—see the interface fc command.
Configures a Fiber Channel link interface—see the interface fc-tunnel
command.
Configures a Fibre Channel over IP (FCIP) interface—see the interface fcip
command.
Configures a Gigabit Ethernet interface—see the interface gigabitethernet
command.
Configures an iSCSI interface—see the interface iscsi command.
Configures a management interface—see the interface mgmt command.
Configures a PortChannel interface—see the interface port-channel
command.
Configures a SAN Volume Controller (SVC) interface for the Caching
Services Module (CSM)—see the interface svc command.
Configures a VSAN interface—see the interface vsan command.
Modification
This command was introduced.
Added the bay | port option.
Chapter 11 I Commands
OL-18089-01, Cisco MDS NX-OS Release 4.x