Information Led Panel - IBM 6000R - Netfinity - 8682 Hardware Maintenance Manual

4
Hard-disk drive status light: Each hot-swap
drive has a hard-disk drive status light. With a
ServeRAID installation, if this amber light is on
continuously, it means that the drive has failed.

Information LED panel

The information panel on the front of the server contains sta-
tus lights.
The following illustration shows the server information panel.
POWER
1
System power: When this green light is on, sys-
tem power is present in the server. When this light
flashes, the server is in standby mode (the system
power supply is turned off and ac current is
present). When this light is off, either a power
supply, AC power, or a light has failed. The power
light is located above and between the power-con-
trol button and the reset button.
Attention:
2
Hard disk drive activity light: This green light is
on when there is activity on a hard disk drive.
3
Ethernet-link status light: When this green light
is on, there is an active connection on the Ether-
net port. The Ethernet transmit/receive activity
light is also located on the Ethernet (RJ-45) con-
nector on the rear of the server.
4
Information light:
the server power supplies are nonredundant or
some other noncritical event has occurred. Check
the diagnostic LED panel for more information
(see "Diagnostic panel LEDs" on page 20).
5
System error light: This amber light is on when
a system error occurs. A light on the diagnostics
LED panel will also be on to further isolate the
error. (For more information, see "Diagnostic
panel LEDs" on page 20.)
5
Ethernet transmit/receive activity light: When
this green light is on, there is activity between the
10
Netfinity 6000R Type 8682 Models 1RY, 2RY
LINK
OK
SCSI ACT LINK OK
RESET
If this light is off, it does not mean
there is no electrical current present
in the server. The light might be
burned out. To remove all electrical
current from the server, you must
unplug the server power cords from
the electrical outlets.
TX
100
MB
RX
100 MB TX/RX
When this amber light is on,
INFO SYS ERROR