IBM 6000R - Netfinity - 8682 Hardware Maintenance Manual page 94

bered microprocessor is the microprocessor from
which the server will start. The lower numbered micro-
processors are used as application microprocessors.
3. If you replace the microprocessors in the server with
microprocessors of a different speed, be sure to set the
microprocessor-core-frequency-selection jumper block
correctly, as described in this section. For a list of sup-
ported microprocessor speeds, see
http://www.ibm.com on the World Wide Web.
4. The server does not support replaceable voltage regu-
lator modules (VRMs).
If you need to install additional microprocessors, install them
in the following order:
• Slot 1 (first slot, connector J34)
• Slot 2 (second slot, connector J35)
• Slot 3 (third slot, connector J36)
• Slot 4 (fourth slot, connector J37)
Attention: The server comes with a terminator card
installed in microprocessor slot 4. To ensure proper
server operation, the terminator card must remain
installed in microprocessor slot 4 until you have
installed microprocessors in slots 1 through 3.
The following illustration is a simplified layout of the micro-
processor connector locations and other microprocessor-
related components on the system board.
Note: The illustrations in this document might differ slightly
from your hardware.
82
Netfinity 6000R Type 8682 Models 1RY, 2RY