IBM 6000R - Netfinity - 8682 Hardware Maintenance Manual page 46

Table 3. Novell NetWare or IntraNetWare ODI driver
messages for the Ethernet controller
PCNTNW-
NW-126
PCNTNW-
NW-127
PCNTNW-
NW-164
PCNTNW-
NW-165
PCNTNW-
NW-167
34
Netfinity 6000R Type 8682 Models 1RY, 2RY
The group bit in the node address
override was cleared.
Explanation: The IEEE address has a
group bit that indicates that an address
belongs to a group of stations. This bit is
used only as a destination address; it
cannot be used as a source address. You
tried to enter a source address with this bit
set. The driver cleared the group bit of the
source address.
Action: None necessary, message is for
information only.
The local bit in the node address
override was set.
Explanation: The local bit in the IEEE
address format indicates that the
addresses are being managed locally. If
you use the node address override
capabilities of this driver to enter a new
address, the local bit must be set. You
entered an address without the local bit
set. The driver has set the local bit.
Action: None necessary, message is for
information only.
The device was not found.
Explanation: The driver cannot find an
Ethernet controller in the server.
Action: Verify that the Ethernet controller
is enabled. If the Ethernet controller is
enabled, go to "Starting the diagnostic
programs" on page 17 to run the
diagnostic programs.
The device was not found at
IOADDRESS.
Explanation: The Ethernet controller
cannot be found at the I/O address
specified.
Action: The Ethernet controller does not
require a parameter for the I/O address.
Remove the I/O address parameter.
PCI scan specified, device not found.
Explanation: The driver cannot locate
the Ethernet controller on the PCI bus.
Action: Verify that the Ethernet controller
is enabled. If the problem persists, go to
"Starting the diagnostic programs" on
page 17 to run the diagnostic programs.