Ndis 4.0 (Windows Nt) Driver Messages - IBM 6000R - Netfinity - 8682 Hardware Maintenance Manual

Table 4. NDIS 2.01 (OS/2) driver messages for the Ethernet
controller
PCNTND-24
PCNTND-25
PCNTND-29
PCNTND-33

NDIS 4.0 (Windows NT) driver messages

This section contains the error messages for the NDIS 4.0
drivers. The explanation and recommended action are
included with each message.
Table 5. NDIS (Windows NT) driver messages for the
Ethernet controller
PermaNet™
Server:
WARNING: PCNET IRQ does not
match PROTOCOL.INI.
Explanation: The interrupt request (IRQ)
setting in the PROTOCOL.INI file does
not match the hardware IRQ setting.
Action: Remove the IRQ setting from the
PROTOCOL.INI file or change the IRQ
setting in the PROTOCOL.INI file to
match the IRQ setting shown in the PCI
Slot/Device Information selection of the
Advanced Setup menu in the
Configuration/Setup Utility program.
PCI scan specified, PCI bus not found!
Explanation: The driver cannot locate
the PCI bus.
Action: Run the diagnostic programs.
WARNING: DMA number is not
necessary for PCI device.
Explanation: The Ethernet controller
does not require a DMA setting.
Action: Remove the DMA setting in the
PROTOCOL.INI file.
PCNET device with specified IOBASE
is already in use.
Explanation: The specified I/O address
number is already in use by another
Ethernet controller or device.
Action: Remove the I/O address setting
in the PROTOCOL.INI file.
No Secondary Adapter Found.
Grouping Mode is disabled.
Explanation: The failover option requires
an adapter that is compatible with the
device driver of the Ethernet controller on
the system board. No such adapter was
found.
Action: Make sure the correct adapter is
installed.
Diagnostics
37