IBM 6000R - Netfinity - 8682 Hardware Maintenance Manual page 100

3. For information on cabling options and using the Netfin-
ity 3-Pack Ultra160 Hot-Swap Expansion option, refer
to the documentation that comes with the option kit.
4. For additional information on cabling, see "Cabling
example for the ServeRAID adapter" on page 71 and
"Cabling the server" on page 107.
5. The hot-swap drive backplane components are shown
at "Installing a hot-swap hard disk drive" on page 76.
Note: The hard-disk drive activity light and hard-disk drive
status light on the backplane match the hard-disk
drive activity light and hard-disk drive status light on
the front of the server (see "Start the server" on page
8).
The rear connectors on the hot-swap-drive backplane
(before repeater card is installed) can be seen at "Installing a
hot-swap hard disk drive" on page 76.
The following illustration shows the rear connectors on the
SCSI repeater card after the repeater card is installed, as
viewed from the rear of the server.
1
SCSI power cable connector
2
I2C cable connector
3
SCSI repeater card cable connector
4
SCSI cable connector
The following illustration shows how to install a Netfinity 3-
Pack Ultra160 Hot-Swap Expansion Kit.
88
Netfinity 6000R Type 8682 Models 1RY, 2RY