IBM 6000R - Netfinity - 8682 Hardware Maintenance Manual page 45

Table 3. Novell NetWare or IntraNetWare ODI driver
messages for the Ethernet controller
PCNTNW-
NW-075
PCNTNW-
NW-079
PCNTNW-
NW-086
PCNTNW-
NW-087
PCNTNW-
NW-091
The Multiple Link Interface Driver
(MLID) cannot be registered with the
Link Support Layer (LSL).
Explanation: An error occurred while the
driver was trying to register with the LSL.
Action: Check the version of the
NetWare or IntraNetWare Operating
System. Make sure that this driver is
correct for the version of NetWare or
IntraNetWare that you are using. Restart
the server.
The Multiple Link Interface Driver
(MLID) did not initialize MSMTx Free
Count.
Explanation: The MSMTx Free Count is
not initialized correctly.
Action: Restart the server. If the problem
persists, go to "Starting the diagnostic
programs" on page 17 to run the
diagnostic programs.
The driver parameter block is too small.
Explanation: The driver parameter block
is too small.
Action: Restart the server. If the
problem persists, go to "Starting the
diagnostic programs" on page 17 to run
the diagnostic programs.
The media parameter block is too
small.
Explanation: The driver media
parameter block is too small.
Action: Restart the server. If the
problem persists, go to "Starting the
diagnostic programs" on page 17 to run
the diagnostic programs.
The hardware configuration conflicts.
Explanation: You tried to load a new
frame type for the existing controller. The
hardware assumptions made in doing so
are incorrect. This error can also occur if
you try to specify a mode (such as,
redundancy) that conflicts with another
specified mode.
Action: Make sure that the hardware
configuration matches the software
settings.
Diagnostics
33