Hard Disk Drive Component Locations - IBM 6000R - Netfinity - 8682 Hardware Maintenance Manual

1
CD-ROM drive
2
Diskette drive
3
Hot-swap bays (up to six)
4
Optional hard disk drives
5
Standard hard disk drives
3.5-inch diskette drive
CD-ROM drive
3 hot-swap hard disk drives
• The server comes with one integrated drive electronics
(IDE) CD-ROM drive and one 3.5-inch, 1.44 MB dis-
kette drive.
• The CD-ROM drive bay (bottom left front) supports
5.25-inch, half-high, removable-media drives. How-
ever, you cannot install additional removable-media
drives in the server.
• The server supports three standard and three optional
1-inch (26 mm) slim-high, 3.5-inch, hot-swap hard disk
drives in the hot-swap bays. The standard hot-swap
bays are bays 1 through 3 (from bottom to top). The
optional hot-swap bays are bays 4 through 6 (from bot-
tom to top). Bays 1 through 3 are located in the stan-
dard hard disk drive cage, to the left of bays 4 through
6 in the optional hard disk drive cage.
Note: The server does not support half-high hot-swap
drives or internal tape drives.
• The hot-swap bays connect to a hot-swap drive back-
plane . The backplane is a printed circuit board behind
the bays.

Hard disk drive component locations

The following illustration shows the hot-swap-drive back-
plane component locations, as viewed from the front of the
server.
Note: The illustrations in this document might differ slightly
from your hardware.
Installing options
75