Diagnostic Error Codes - IBM 6000R - Netfinity - 8682 Hardware Maintenance Manual

Note: The System Error LED will also be on.
Diagnostic
Panel LED
PS3 LED on
SP Bus on
Event Log
Non Red
TEMP LED on

Diagnostic error codes

Note: In the following error codes, if XXX is 000 , 195 , or
197 do not replace a FRU. The description for these
error codes are:
000
195
197
For all error codes, replace/follow the FRU/Action
indicated.
160
Netfinity 6000R Type 8682 Models 1RY, 2RY
1. Check the DC Good LED on
power supply 3. If off, replace
power supply 3.
2. Power Backplane.
1. SP Bus card.
2. System Board.
Not implemented at this time.
1. Check PS1, PS2, and PS3 LEDs
and take the actions for those
indicators.
2. See "Diagnostic panel error LEDs"
on page 157.
1. Ambient temperature must be
within normal operating
specifications. See "Features
and specifications" on page 3.
2. Ensure fans are operating
correctly.
3. Examine System Error Log.
a. DASD over recommended
b. System over recommended
The test passed.
The Esc key was pressed to abort the test.
This is a warning error and may not indi-
cate a hardware failure.
FRU/Action
temperature (DASD LED
also on)
(1) Overheating hard drive
(2) DASD Backplane
(3) System Board
temperature for CPU X
(where X is CPU 1, 2, 3, or 4)
(CPU LED also on)
(1) CPU X