Pci Switch Card - IBM 6000R - Netfinity - 8682 Hardware Maintenance Manual

PCI switch card

Before you begin:
• Read "Safety information" on page 196.
• Review the information in "Before you begin" on page
63.
1
Switch card latches
2
Switch card assembly
1. Power-off the server, if it is on.
2. Disconnect the server from the electrical outlet.
3. Remove the top cover (see "Removing the server top
cover and bezel" on page 67).
4. Disconnect the switch card cable from the system
board.
5. Disengage the switch card:
a. Press the switch card latches toward the front and
sides of the server.
b. Push the latches through the notches.
6. When the switch card latches have been disengaged
from the notches, gently pull the switch card free and
lift it up and out of the server.
Note: You may have to tilt the top of the switch card
toward the front of the server when removing it.
7. To replace the switch card, reverse the steps above.
FRU information (service only)
149